Table of Contents
UEFI boot menu tree
- Device Manager
- Driver Health Manager
- RAM Disk Configuration
- Tls Auth Configuration
- SynQuacer Platform Settings
- PCIe x4 slot max speed
- PCIe x1 slot 1 max speed
- PCIe x1 slot 2 max speed
- Enable on-board eMMC
- O/S Hardware Description
- Console Preference Selection
- 96boards Mezzanine options
- iSCSI Configuration
- Network Device List
- Boot Manager
- Boot Maintenance Manager
- Boot Options
- Add Boot Option
- Delete Boot Option
- Change Boot Order
- Driver Options
- Console Options
- Boot From File
- Boot Options
Configure boot options
Add boot option
To add new grub boot option:
- Select Boot Maintenance Manager and Boot Options
- Select Add Boot Option
- Select entry at File Explorer, note that only FAT/VFAT partition is listed here
- Find EFI grub application and select
- Select Input the description and enter boot option label
- Select Commit Changes and Exit
Delete boot option
- Select Boot Maintenance Manager and Boot Options
- Select Delete Boot Option from the Boot Options menu
- Select Debian, then press F10
- Select Commit Changes and Exit
Change boot order
- Select Boot Maintenance Manager and Boot Options
- Select Change Boot Order
- Select the boot option list
- Change order with “+” or “-“
- Make sure if the order changed and select Commit Changes and Exit
Configure platform settings
Set eMMC enable
- Select Device Manager and SynQuacer Platform Settings
- Select Enable on-board eMMC and choose Enabled
- Press Escape and then press Y to save and exit
- Press Escape again, to return to the main menu
- Select Reset
Select hardware description
- Select Device Manager and SynQuacer Platform Settings
- Select O/S Hardware Description and choose ACPI or Device Tree
- Press Escape and then press Y to save and exit
- Press Escape again, to return to the main menu
- Select Reset