Set up WiFi

Connect to a WiFi AP

  • Edit wpa_supplicant.conf using: vi /data/misc/wifi/wpa_supplicant.conf
  • Fill in the ssid and psk of wifi as follows: 
    update_config=1
eapol_version=1
ap_scan=1
fast_reauth=1
pmf=1
p2p_add_cli_chan=1
network={
  ssid=”wifissid1”
  psk=”wifipsk1”
}
Network={
  ssid=”wifissid2”
  psk=”wifipsk2”
}
  • Restart the device and connect to wifi.
  • Run the following commands to confirm that the device is connected to wifi: ```Shell ifconfig wlan0 wlan0 Link encap:Ethernet HWaddr 00:0A:F5:83:66:EF inet addr:192.168.43.92 Bcast:192.168.43.255 Mask:255.255.255.0 inet6 addr: fe80::20a:f5ff:fe83:66ef%1736140884/64 Scope:LinkUP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:15 errors:0 dropped:0 overruns:0 frame:0 TX packets:18 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:3000 RX bytes:1864 (1.8 KiB) TX bytes:1828 (1.7 KiB)

ping www.qualcomm.com PING www.qualcomm.com (23.59.93.51): 56 data bytes 64 bytes from 23.59.93.51: seq=0 ttl=48 time=171.722 ms 64 bytes from 23.59.93.51: seq=1 ttl=48 time=163.070 ms 64 bytes from 23.59.93.51: seq=2 ttl=48 time=244.932 ms 64 bytes from 23.59.93.51: seq=3 ttl=48 time=166.135 ms ```